 Stock Seats -- Wanted stock 510 seats for a 2 door. Condition doesn't really matter. |
| L20b stock carb wanted -- what the title says |
z2.2 motor -- Testing the waters here. Looking for a napz motor and 5spd tranny from a 81-83 720 pickup, to swap into my wagon. Please email me. I am willing to travel a bit to get this motor so let me know what you got.
TIA |
| Datsun parts wanted -- I have a 1972 Datsun 510 Road Racer. I'm looking for a full radiator support from left to right side and right side inner fender in front of right side tower. |
| wiper parts -- Have 73 510 need a wiper motor and the comp.mech that attaches to motor uuder the cowl.Have the arms also looking for a left side mounted ignition switch on colume |
WTB: L24/L16 high compression pistons -- Looking for a set of L24(L16) .040 over high compression pistons. Need 6 but will consider less. Prefer new but used in good condition OK too. Email to TBork95577 "@" AOL.com or PM here.
Thanks! Tom |
| L18 or L20 Wanted -- Looking for a stock engine or short block for my '79 610 |
| 3.9 diff or higher needed -- Looking for r200 or r180 differential with 3.9 or higher ratio. Open diff is OK. also looking for r160 stub axles, |
Z20/Z22 EFI bits -- Having probably gone as far as I can with my 38mm dual SUs, I've decided that I want to go the EFI route, using the old Z22/Z20 EFI bits and pieces. I'd like the setup that uses an O2 sensor, since I've got one in my car right now, and I might as well make use of it.
If anybody has the whole setup in their garage taking up space, I'll be glad to buy it off of you, and maybe consider partial swap with my SUs if someone wants to buy a known-running set. Let me know what you have. |
| SWAY BAR WANTED -- F/R SWAY BAR WANTED FOR 510 818-590-2362 |
| BRE 510 Style Adjustable Tension Rods -- I am looking for a set of 510 BRE style adjustable tension rods. These used an MG steering rack inner socket or similar. Am building 70's vintage 510....Do not want the newer style tension rods that are readily available on Ebay etc.Please let me know what you have....cash or trades ? I have tons of NOS Datsun parts to bargain with. Also looking for L/R tail lamp lens 26526-N2800 new only. call after 6 pm CA time ..thanks..Robert |
wanted engine wiring harness or one built -- im looking for a good harness my car ia a 71 2door and my engine harness is shot i have it but it needs redone or a new one or one built from what i have and have the extra wires added and the ones taken out that i dont need anymore. let me know i have a couple datsun harness just need some help makin up one that will be nice and have everything i need. also im in need of a drivers side front window for a 2 door as well.
thanks justin |
| tail light housings / wiring -- Needing the wiring for stock coupe of 4dr. tail lights. The bulb holders, and harness to the housing is what i am really after. But i can see not wanting to part with just the wire, will to consider buying the whole assembly. But per chance you have some old rusted or busted ones............... |
turbo -- I am looking for turbo parts for L series engine. Please email me any parts you may have .
thanks, mike |
| Need a 510 Bumper -- I'm looking for a clean front bumper for a 73 510. Mine isn't that bad, if anybody knows or somebody that can straighten and rechrome. Thanks for any help. |
Personal Wheel -- I am looking for a small personal steering wheel, 3 silver spokes, I just need the wheel.
Please email if you have one you would like to sell.
thanks mike |
| looking for door panel -- looking for a red burgundy front passenger 4dr door panel for a 69 4dr 510 , shoot me an email with what you have. thank you |
Trunk Latch -- hey everyone im in need of everyting that keeps the trunk close. I dont need the Locks. The best way i can describe it is i need the part on the trunk itself and the par that goes on the tail light panel.
thanks rudy |
| competition oil pan -- looking for a 7 quart competition oil pan. |
(Beta) 
Phone: 
E-Mail: blk2comm@gmail.com